How to avoid all resin carbon tape in the printing process blockage or broken tape problem?

To avoid the problem of blockage or broken tape in the printing process of all resin carbon tape, you can consider and operate from the following aspects:

First, choose high-quality carbon strips and labels

1.Quality assurance: Select high-quality all-resin carbon tape and matching label paper to ensure that their material, thickness, adhesion and other characteristics are compatible with each other, in order to reduce the blockage or broken tape caused by material incompatibility.

2.Formal channels: Buy carbon belts and labels through formal channels to avoid using inferior or counterfeit products, which are often of unstable quality and prone to printing problems.

Second, set the printer parameters reasonably

1.Temperature adjustment: Set the printing temperature of the printer reasonably according to the material characteristics of the carbon belt and label. Too high temperature may cause the carbon strip to melt and stick, and then lead to blockage or broken tape; Too low a temperature may affect the printing effect.

2.Speed and pressure: Properly adjust the printing speed and head pressure of the printer to ensure that they match the material of the carbon strip and label. Too fast a printing speed or too much head pressure can increase the risk of carbon band breakage.

Third, the correct loading and maintenance of carbon belt

1.Correct loading: According to the requirements of the printer manual, the carbon strip is properly loaded to ensure that the carbon strip is flat, wrinkle-free, and the tension is moderate. Improper loading may lead to distortion and fracture of the carbon belt during printing.

2.Regular cleaning: Regularly clean the printer's printing head, carbon belt sensor and other components to remove the attached ink, dust and other impurities, to keep the printer in good working condition. This helps to reduce the blockage problem caused by the accumulation of impurities.

Fourth, pay attention to the printing environment

1.Temperature and humidity control: Keep the temperature and humidity of the printing environment appropriate to avoid too high or too low temperature and excessive humidity fluctuations on the carbon strip and label. Extreme environmental conditions may cause the carbon strip to deform, fracture, or decrease in label adhesion.

2.Electrostatic protection: In some cases, static electricity may also have an adverse effect on the carbon strip. You can reduce the impact of static electricity on carbon belts by increasing the ambient humidity and using antistatic materials.

Fifth, timely replacement of aging carbon belts

1.Observe the condition of the carbon belt: Check the condition of the carbon belt regularly, including appearance, color, toughness, etc. If the carbon belt is found to be aging, brittle, fractured and other phenomena, a new carbon belt should be replaced in time.

2.Follow the service life: according to the use of the carbon belt instructions and the actual situation, the service life of the carbon belt is reasonably estimated, and the new carbon belt is replaced in time after reaching the service life.

In summary, through the selection of high-quality carbon tape and label, reasonable setting of printer parameters, correct loading and maintenance of carbon tape, pay attention to the printing environment and timely replacement of aging carbon tape and other measures, can effectively avoid the resin carbon tape in the printing process blockage or broken tape.