The correct installation of reinforced wax based carbon ribbon requires following the following steps:
1、 Preparation work
Choose the appropriate ribbon: Ensure that the width of the ribbon matches the width of the label paper, and that the type of ribbon (such as wax based, mixed based, resin based) is suitable for your printing needs and label paper type. For enhanced wax based carbon ribbon, it is suitable for printing on general paper, especially for materials with slightly uneven surfaces.
Turn off power: Before installing a new ribbon, be sure to turn off the printer's power and unplug the power cord to ensure safe operation.
Preparation tools: Prepare tools such as wrenches and screwdrivers as needed for disassembling and installing carbon ribbons.
2、 Installation steps
Open the printer cover: Follow the instructions in the printer manual to open the top or side cover of the printer, exposing the ribbon assembly and printer rollers.
Cleaning the carbon ribbon compartment: Before installing a new carbon ribbon, clean the dust and debris inside the carbon ribbon compartment to ensure smooth operation of the carbon ribbon.
Remove old carbon ribbon: If there is already an old carbon ribbon in the printer, carefully remove and dispose of it properly to avoid dirtying hands or the inside of the printer.
Install new carbon ribbon:
Confirm the front and back of the carbon ribbon: Reinforced wax based carbon ribbon usually has one dark side (with carbon powder) and one bright side (without carbon powder). Ensure that the carbon side is facing the print head, that is, the side in contact with the paper.
Install carbon ribbon shaft: Place the new reinforced wax based carbon ribbon roll on the carbon ribbon shaft, ensuring that the carbon ribbon roll is flat and the two ends of the shaft are smooth and undamaged. Then, insert the ribbon shaft into the ribbon shaft slot of the printer, ensuring that the shaft is aligned correctly and can rotate freely.
Passing through the guide groove: Pull the ribbon out of the ribbon shaft and pass it through the guide groove of the printer. During the process of passing through, ensure that the carbon ribbon is not wrinkled or twisted, and smoothly reaches the print head.
Fixed ribbon: Fix the end of the ribbon onto the ribbon fixing device of the printer to ensure that it does not move during the printing process. If the printer has a carbon ribbon tension adjustment device, adjust it to the appropriate tension, neither too tight nor too loose.
Check the path of the carbon ribbon: After installation, carefully check the path of the carbon ribbon to ensure that it is not stuck or deviating from the correct path.
3、 Testing and adjustment
Close the printer cover: After confirming that the ribbon is installed correctly, close the printer cover.
Reconnect power: Plug the power cord back into the printer and turn on the power.
Test printing: Before formal printing, conduct a test printing to ensure that the carbon ribbon is installed correctly and the printing effect meets expectations. If any problems are found, adjust the position or tension of the carbon ribbon in a timely manner.
4、 Precautions
Avoid contamination: During installation and printing, avoid direct finger contact with the printing surface of the ribbon to prevent contamination of the ribbon and affect the printing effect.
Storage environment: Unused carbon ribbon should be stored in a dry, cool place, away from direct sunlight and high temperature environment, to extend the service life of the carbon ribbon.
Regular cleaning: Regularly clean the ribbon channel and print head of the printer to maintain optimal performance.
Follow the manual: Different printers may have different installation steps and precautions, so it is best to follow the instructions in the printer user manual for operation.
By following the above steps and precautions, you can correctly install the enhanced wax based carbon ribbon and ensure the normal operation and printing quality of the printer.